I am in the middle of replacing my oil filter housing.
Can anyone share the torque specs of the oil filter housing bolts, oil pressure sensor and oil cooler bolts please?
Thanks!
05-15-2018 08:20 AM #2
Veteran Member Four Rings
'06 APR S2+ A4 2.0T 6 Speed DD - current '12 Q5 2.0T P+ Built engine/CTS K04/IE tune - current '05 Ford F250 XLT 4x4 BP'd 6.0 - current '01.5 APR S3 S4 Avant 6 Speed - sold '04 Goodwood S4 6 Speed - sold '91 Jetta GL 1.8 8v manual swap - sold '99 SVT Cobra 308whp/308wtq - sold '01 Mustang GT - sold '88 Mustang LX 5.0 - sold '95 Jeep Cherokee Country - sold
05-15-2018 08:26 AM #3
Veteran Member Three Rings
Thank you
05-15-2018 08:27 AM
#4
Veteran Member Four Rings
happy
wrenching
Oh and the sensor, probably about the same. Haven't done one on this car but usually just snug to seat it is plenty. If I remember I will check the bentley when I get home
'06 APR S2+ A4 2.0T 6 Speed DD - current '12 Q5 2.0T P+ Built engine/CTS K04/IE tune - current '05 Ford F250 XLT 4x4 BP'd 6.0 - current '01.5 APR S3 S4 Avant 6 Speed - sold '04 Goodwood S4 6 Speed - sold '91 Jetta GL
1.8 8v manual swap - sold '99 SVT Cobra 308whp/308wtq - sold '01 Mustang GT - sold '88 Mustang LX 5.0 - sold '95 Jeep Cherokee Country - sold
05-15-2018 08:59 AM
#5
Veteran Member Three Rings
I can confirm 15NM or 132in-lbs for the housing. I only have a Haynes manual, the other two either aren�t listed or I grazed over them.
2005.5 A4 Avant; TSI cam follower conversion. Build Thread
99.5 1.8TQM;
Maestro, GTX2867R, and a ton more mods. RIP
