ManualView the manual for the Graco Pack 'n Play Playard here, for free. This manual comes under the category Not categorized and has been rated by 2 people with an average of a 9.3. This manual is available in the following languages: English. Do you have a question about the Graco Pack 'n Play Playard or do you need help? Ask your question here Frequently Asked QuestionsCan't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Graco Pack 'n Play Playard below. Is your question not listed? Ask your question here 13 361-10-99 14 15 16 To Use Your Chang ing Table Parts List CHECK that you have all parts listed below BEFORE assembling your changing table. No tools required. Long tube (2) Short tube (2) Changing pad Accessory bag Changing table Step 1. Lay changing table flat on floor with short side in front of you and belt facing up. Gently slide one long tube into opening on long side exactly as shown. Step 2. Slide one short tube into opening on end as shown. For proper orientation, be sure folding side of hinge faces pad as shown. DO NOT insert other short tube at this time. Fold side of hinge Long side Short side Step 3. Turn up long tube so that its end points down. into opening on end of short tube as shown. DO NOT slide short tube up around the bend of long tube until you have finished next step. Make sure fabric does not get caught in opening when inserting long tube into short tube. Step 4. Repeat step 3 on other end of short tube, then slide short tube ends up onto long tubes. TO AVOID TEARING FABRIC, slide this end up before proceeding with step 5. Step 5. Repeat steps 2 and 3 on other end of changing table. If the short tubes have been inserted correctly, the changing table should be able to FOLD UP in the center as shown. Step 6. Place pad in changing table with vinyl side up. Pull belt straps through holes in center of pad. Step 7. Insert VELCRO ® straps into the four slots at the corners of changing table and attach to VELCRO ® on underside of changing table. This will prevent pad from moving. Step 8. Place changing table on Pack N Play as shown. You may use your changing table with or without your bassinet installed. Make sure tubes are securely over the sides of the Pack N Play. table is supported by the Pack N Play by pushing firmly down into center of changing table. Short tube side Slide ends up To Use Accessory Bag If your bassinet is already installed, unsnap the four snaps on the bassinet end flap from either end of Pack N Play. Step 1. Snap accessory bag onto end of Pack N Play with four snaps as shown. Step 2. Snap bassinet end flap over the accessory bag with the four snaps. To Fold Changing Table Step 1. Pull up on waist belt straps to fold. Step 2. Ends of long tubes must point up when folded as shown. Fold up Ends of tubes point up To protect your child from falls and other injuries: using the changing table. Always use waist belt when child is on the changing table. Never leave child unattended. The changing table is designed for use only with this Graco Pack N Play. Do not attempt to use it with any other product. Before each use, make sure the changing table is properly secured to the Pack N Play by pushing down firmly in the middle of the changing table. The changing table should not fall. Do not use the changing table as a sleeping or play area. Weight limit for the changing table is 25 pounds (11.3 kg). Do not use the changing table as extra storage. Always remove the changing table when your child is in the Pack N Play. The Pack N Play changing table can be used on the floor without being attached to the Pack N Play. Never place the changing table on a piece of furniture, bed, counter or any raised surface from which the changing table or your child could fall. Step 3. To carry or store your changing table with your folded Pack N Play, see To Cover Your Pack N Play section in these instructions. CHANGING TABLE INSTRUCTIONS (ON CERTAIN MODELS) |